RCA RCU900 User Guide - Page 11

RCU900_IB_revC.qxp 12/3/02 9:45 Page 11 9. The Autosearch sends the next code in the list every three seconds. Note: The Autosearch can take a significant amount of time, since there are many codes in the list. 10. To speed up the Autosearch, you can manually override the process and temporarily speed it up by pressing the normal search keys (CH+, CH-, ON•OFF, PLAY, LCD UP, and LCD DOWN keys) in both forward and reverse directions. 11. If your device responds to the command, and the RCU 900 sends the next code before you have a chance to press the LCD OK key, you can backtrack through the code library by pressing CH- or the DOWN ARROW. You can change the direction to forward once again by pressing the ON/OFF, CH+, LCD UP ARROW, or PLAY keys. 12. Once the device to be controlled responds to the commands, press and release the LCD OK key to install the code. 13. The touchscreen returns to the Main Setup Screen. The Code Search entry is now complete. 14. Press CLEAR on the Main Setup Screen to exit Setup Mode. Code Identification Code Identification allows you to find out what codes are programmed in the remote under a given mode (TV, VCR, DVD, etc.). To find out the currently programmed code, follow these steps: 1. Press and hold the SETUP key on the rubber keypad until the LED indicator light remains on and the touchscreen shows the Main Setup Screen. This process takes approximately 2-3 seconds. 2. Release the SETUP key. 3. Press and release the LCD CODE key. The LED indicator light blinks once to indicate acceptance of the keypress. 4. The touchscreen now shows Device Setup Screen. Press and release the device key on the rubber keypad for the device whose code you want to identify (TV, VCR, SAT/CBL, etc.). The LED indicator light blinks once to indicate acceptance of the keypress. 5. The touchscreen now shows the Code Setup Screen. Press and release the SETUP key. The LED indicator light blinks once to indicate acceptance of the keypress. 6. The touchscreen now shows the Code ID Setup Screen (initially blank except for LCD SETUP, INFO and CODE keys). The touchscreen then shows the code, using the LCD digits. The digits in the three-digit code are shown in sequence for 11