Ricoh P C301W Users Guide - Page 184
key to select the authentication method, and then press the [OK] key., list
View all Ricoh P C301W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 184 highlights
8. Configuring Network Settings 6. Press the [ ] or [ ] key to select [Enable Wireless (Wi-Fi)], and then press the [OK] key. 7. Press the [ ] or [ ] key to select [Enable], and then press the [OK] key. 8. Press the [Menu] key to return to the Initial screen. 9. Turn off the machine, and then turn it back on. 10. Press the [Menu] key. 11. Press the [ ] or [ ] key to select [Wi-Fi Setup Wizard], and then press the [OK] key. 12. Enter the administrator password if required. 13. Press the [ ] or [ ] key to select SSID of the router (access point) from the searched SSID list, and then press the [OK] key. 14. Press the [ ] or [ ] key to select the authentication method, and then press the [OK] key. The next steps differ depending on the authentication method that you have selected. Proceed to Step 18 of the appropriate section. • If the authentication method is set to [WPA2-PSK] or [Mixed Mode], proceed to Step 18. • If the authentication method is set to [Open System] or [Shared Key], proceed to Step 21. 15. Enter the encryption key using the [ ] or [ ] key, and then press the [OK] key. As the passphrase, you can enter either 8 to 63 ASCII characters (0x20-0x7e) or 64 hexadecimal digits (0-9, A-F, a-f). • To go to the next characters, press the [OK] key. • Press the [Escape] key to clear all characters. 16. Press the [OK] key. After connecting to the network, the Wi-Fi screen is displayed. 17. Press the [ ] or [ ] key to select [Wi-Fi Status], and then press the [OK] key. When "Connected" is displayed, the connection has been established. • When "Connecting" is displayed, the connection is being established. • When "Disconnected" is displayed, the connection has not been established. Start again from the beginning. 18. Press the [ ] or [ ] key to select the encryption method, and then press the [OK] key. The maximum number of characters that can be entered in the encryption key field depends on the encryption method settings. 19. Enter the encryption key using the [ ] or [ ] key, and then press the [OK] key. • To go to the next characters, press the [OK] key. • Press the [Back] key to clear all characters. 20. Enter the ID using the [ ] or [ ] key, and then press the [OK] key. The ID is used for identifying the encryption key. You can register four encryption keys (ID 1 to 4). 182