Ridgid BS1400 Owners Manual - Page 15
Assembly - accessories
View all Ridgid BS1400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
ASSEMBLY UNPACKING This product requires assembly. n Carefully remove the tool and any accessories from the box. Place it on a level work surface. NOTE: This tool is heavy. To avoid back injury, lift with your legs, not your back, and get help when needed. n Inspect the tool carefully to make sure no breakage or damage occurred during shipping. n Do not discard the packing material until you have carefully inspected the tool, identified all loose parts, and satisfactorily operated the tool. n Remove the protective oil that is applied to all unpainted metal surfaces. Use any ordinary household type grease and spot remover. n Apply coat of paste wax to the saw table. n The saw is factory set for accurate cutting. After assembling it, check for accuracy. If shipping has influenced the settings, refer to specific procedures explained in the operation and maintenance sections of this manual. n If any parts are damaged or missing, please call 1-866-539-1710 for assistance. WARNING: If any parts are missing, do not operate this tool until the missing parts are replaced. Failure to do so could result in possible serious personal injury. n Put the leveling feet through the holes in the bottom of each leg. n Thread another hex nut on each of the leveling feet and hand tighten until they are next to the bottom support of the leg. LEG HEX NUTS LEVELING FOOT Fig. 10 WARNING: To reduce the risk of injury from unexpected saw or work movement, leveling feet must be adjusted so that saw does not rock. After the band saw has been attached to the leg stand, it will be necessary to adjust the leveling feet. WARNING: Do not attempt to modify this tool or create accessories not recommended for use with this tool. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury. WARNING: Do not connect to power supply until assembly is complete. Failure to comply could result in accidental starting and possible serious personal injury. CARRIAGE BOLT WASHERS LOCK WASHERS HEX NUTS LEG BRACE (LONG) LEG BRACE (SHORT) LEG ATTACHING LEVELING FEET See Figure 10. n Locate the following items: 4 leveling feet 8 hex nuts, (3/8-16) n From the loose parts find the following items: 4 legs n Thread a hex nut on each of the leveling feet and screw it down towards the rubber foot. 15 BASE Fig. 11