Ridgid WD1956 Owners Manual - Page 6

Removing/Installing the Metal Handle - vac

Get Ridgid WD1956 PDF manuals and user guides View all Ridgid WD1956 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 6 highlights

SP6731-1 16 Gallon E S 2/3/12 2:06 PM Page 6 Removing/Installing the Metal Handle Your Metal handle comes packaged in the carton in the reverse direction. You must pull the metal handle completely out of Vac and reinstall the handle in the correct direction, bent area facing away from the back of the Vac, before continuing. Metal Handle in Reversed Position (As Shipped) Installing Handle Press and hold release buttons while installing handle into handle receptacles in drum (See illustration). NOTE: An audible snap of release buttons indicates successful engagement of handle. Lowering Handle for Storage To store Wet/Dry Vac, press and hold release buttons while firmly sliding handle down. Correct Position Removing Handle Press and hold release buttons, as shown. While firmly pushing in release buttons, pull handle upwards to remove (see illustration). Installing Tool Holder Install tool holder as shown with extension wand holders facing unit. Moving Position Tote Snaps Tote Straps (5) Storage Position Handle Extension Wand Storage Locations 6

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
Removing/Installing the Metal Handle
6
Your Metal handle comes packaged in
the carton in the reverse direction. You
must pull the metal handle completely out
of Vac and reinstall the handle in the
correct direction, bent area facing away
from the back of the Vac, before
continuing.
Installing Handle
Press and hold release buttons while
installing handle into handle receptacles
in drum (See illustration).
NOTE:
An audible snap of release
buttons indicates successful engagement
of handle.
Lowering Handle for Storage
To store Wet/Dry Vac, press and hold
release buttons while firmly sliding handle
down.
Removing Handle
Press and hold release buttons, as
shown. While firmly pushing in release
buttons, pull handle upwards to remove
(see illustration).
Installing Tool Holder
Install tool holder as shown with
extension wand holders facing unit.
Correct
Position
Storage
Position
Moving
Position
Metal Handle in
Reversed Position
(As Shipped)
Tote Snaps
Tote
Straps (5)
Handle
Extension
Wand
Storage
Locations
SP6731-1 16 Gallon E S
2/3/12
2:06 PM
Page 6