Rocketfish RF-TVMP20 User Manual (English) - Page 15

RF-TVMP20 TV Wall Mount STEP 8 - Adjusting the vertical position, the tilt, and the horizontal position Important! You will need to adjust this product after installation is complete. Make sure all your equipment is properly installed on the product before adjusting. This product should move smoothly and easily through the full range of motion and stay where you set it. If movements are too easy or diffcult or if product does not stay in desired position, follow the adjustment instructions to create smooth and easy movements. NOTE: Depending on your product and the type of adjustment, it may take many turns to notice a difference. Any time equipment is added or removed from this product, resulting in a change in the weight of the mounted load, you should repeat these adjustment steps to ensure safe and optimum operation. 1 To increase or decrease the lift tension setting, use the 4mm Allen wrench (P-A). 2 To increase or decrease the tilt tension setting, use the 4mm Allen wrench (P-A). 3 Using the 2.5mm Allen wrench (P-B) adjust the tension of the horizontal movement. If this product moves too easily from side-to-side, increase the tension (+). If the product is too difficult to move from side-to-side, decrease the tension (-). Adjusting the factory-set tension Increase If TV weight exceeds product's factory setting, it won't stay up when raised. To prevent TV from sagging downward, increase tension setting. 1 P-A Decrease If TV weight is 3 lower than product's factory 2 setting, it won't stay down when lowered. To prevent TV from drifting upward, decrease tension setting. You'll need P-A 4 mm Allen wrench P-B 2.5 mm Allen wrench For customer service, call: 1-800-620-2790 (U.S. and Canada) or 01-800-926-3010 (Mexico) Need help? Call 1-800-620-2790 (U.S. and Canada) or 01-800-926-3010 (Mexico) 15