Ryobi RYI2200 User Manual 3 - Page 13

Generator Capacity, Power Management - power refrigerator

Page 13 highlights

ELECTRICAL GENERATOR CAPACITY Make sure the generator can supply enough continuous (running) and surge (starting) watts for the items you will power at the same time. Follow these simple steps. 1. Select the items you will power at the same time. 2. Total the continuous (running) watts of these items. This is the amount of power the generator must produce to keep the items running. See the wattage reference chart at right. 3. Estimate how many surge (starting) watts you will need. Surge wattage is the short burst of power needed to start electric motor-driven tools or appliances such as a circular saw or refrigerator. Because not all motors start at the same time, total surge watts can be estimated by adding only the item(s) with the highest additional surge watts to the total rated watts from step 2. Example: Tool or Appliance Running Watts* Starting Watts* Refrigerator 700 1350 Portable Fan Laptop 46 in. Flat Panel Television Light (75 Watts) 40 250 190 75 1255 Total Running Watts 120 250 190 75 1350 Highest Starting Watts Total Running Watts Highest Starting Watts Total Starting Watts Needed 1255 + 1350 2605 POWER MANAGEMENT To prolong the life of the generator and attached devices, it is important to take care when adding electrical loads to the generator. There should be nothing connected to the generator outlets before starting its engine. The correct and safe way to manage generator power is to sequentially add loads as follows: 1. With nothing connected to the generator, start the engine as described later in this manual. 2. Plug in and turn on the first load, preferably the largest load you have. 3. Permit the generator output to stabilize (engine runs smoothly and attached device operates properly). 4. Plug in and turn on the next load. 5. Again, permit the generator to stabilize. 6. Repeat steps 4 and 5 for each additional load. Never add more loads than the generator capacity. Take special care to consider surge loads in generator capacity as previously described. NOTICE: Do not overload the generator's capacity. Exceeding the generator's wattage/amperage capacity may damage the generator and/or electrical devices connected to it. Application/Equipment Estimated Estimated* Starting Starting Watts* Watts Emergency / Home Standby Lights (qty. 4 x 75 W) Refrigerator 46 in. Flat Panel Television Satelite Receiver Portable Fan Heater Laptop Slow Cooker Radio Job Site Electric Drill − 3/8 in. Quartz Halogen Work Light Reciprocating Saw Circular Saw − 7-1/4 in. Miter Saw − 10 in. Air Compressor − 1/4 HP Airless Sprayer − 1/3 HP 300 700 190 250 40 1300 250 270 50 600 1000 960 1400 1800 970 600 300 1350 190 250 120 1300 250 270 50 1000 1000 1920 2300 1800 1600 1200 *Wattages listed are approximate. Check tool or appliance for actual wattage. 9 - English

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64

9 — English
ELECTRICAL
Application/Equipment
Estimated
Starting
Watts*
Estimated*
Starting
Watts
Emergency / Home Standby
Lights (qty. 4 x 75 W)
300
300
Refrigerator
700
1350
46 in. Flat Panel Television
190
190
Satelite Receiver
250
250
Portable Fan
40
120
Heater
1300
1300
Laptop
250
250
Slow Cooker
270
270
Radio
50
50
Job Site
Electric Drill − 3/8 in.
600
1000
Quartz Halogen Work Light
1000
1000
Reciprocating Saw
960
1920
Circular Saw − 7-1/4 in.
1400
2300
Miter Saw − 10 in.
1800
1800
Air Compressor − 1/4 HP
970
1600
Airless Sprayer − 1/3 HP
600
1200
*Wattages listed are approximate. Check tool or appliance for actual wattage.
GENERATOR CAPACITY
Make sure the generator can supply enough continuous (run-
ning) and surge (starting) watts for the items you will power
at the same time. Follow these simple steps.
1. Select the items you will power at the same time.
2. Total the continuous (running) watts of these items. This
is the amount of power the generator must produce to
keep the items running. See the wattage reference chart
at right.
3. Estimate how many surge (starting) watts you will need.
Surge wattage is the short burst of power needed to
start electric motor-driven tools or appliances such as a
circular saw or refrigerator. Because not all motors start
at the same time, total surge watts can be estimated by
adding only the item(s) with the highest additional surge
watts to the total rated watts from step 2.
Example:
Tool or Appliance
Running
Watts*
Starting
Watts*
Refrigerator
700
1350
Portable Fan
40
120
Laptop
250
250
46 in. Flat Panel
Television
190
190
Light (75 Watts)
75
75
1255 Total
Running Watts
1350 Highest
Starting Watts
Total Running Watts
1255
Highest Starting Watts
+ 1350
Total Starting Watts Needed
2605
POWER MANAGEMENT
To prolong the life of the generator and attached devices,
it is important to take care when adding electrical loads to
the generator. There should be nothing connected to the
generator outlets before starting its engine. The correct and
safe way to manage generator power is to sequentially add
loads as follows:
1. With nothing connected to the generator, start the engine
as described later in this manual.
2. Plug in and turn on the first load, preferably the largest
load you have.
3. Permit the generator output to stabilize (engine runs
smoothly and attached device operates properly).
4. Plug in and turn on the next load.
5. Again, permit the generator to stabilize.
6. Repeat steps 4 and 5 for each additional load.
Never add more loads than the generator capacity. Take
special care to consider surge loads in generator capacity
as previously described.
NOTICE:
Do not overload the generator’s capacity. Exceeding the
generator’s wattage/amperage capacity may damage
the generator and/or electrical devices connected to it.