Samsung NE59J7630SG/AA User Manual - Page 42
Troubleshooting
View all Samsung NE59J7630SG/AA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Troubleshooting Troubleshooting Samsung works hard to ensure that you don't have problems with your new electric range. If you run into unexpected trouble, look first for a solution in the table below. If, after trying the suggested solution, you're still having trouble, call Samsung at 1-800-SAMSUNG (1-800-726-7864). Installtion Problem The range is not level. The appliance must be accessed for servicing and cannot be moved easily. Possible cause The appliance has been installed improperly. The floor is sagging or sloping. The kitchen cabinets are not properly aligned and make the range appear to be not level. The kitchen cabinets are not square and too close to the appliance. Carpet is interfering with movement of the range. Solution • Place the oven rack in the center of the oven. Place a level on the oven rack. Adjust the leveling legs at the base of the range until the oven rack is level. • Insure the floor is level and strong and stable enough to adequately support the range. Contact a carpenter to correct the situation. Insure the cabinets are square and provide sufficient room for installation. Contact a builder or installer to make the appliance accessible. Provide sufficient space so the range can be lifted over the carpet. CONTROL DISPLAY Problem The Display goes blank. The Display flashes. Possible cause A fuse in your home may be blown or the circuit breaker tripped. There was a power failure. Solution Replace the fuse or reset the circuit breaker. Reset the clock. COOKTOP Problem Possible cause The surface units will not maintain a rolling boil or will not cook fast enough. You may be using inappropriate cookware. In some areas, the power (voltage) may be low. The surface units will not turn on. A fuse in your home may be blown or the circuit breaker tripped. The cooktop controls are set improperly. Areas of discoloration Food spillover was not on the cooktop. cleaned. The surface is hot and the model features a lightcolored cooktop. Solution Use pans which are flat and match the diameter of the surface unit selected. Cover the pan with a lid until the desired heat is obtained. Replace the fuse or reset the circuit breaker. Check if the correct control is set for the surface unit you are using. Refer to the section on the care and cleaning of the glass cooktop on pages 38-39. This is normal. The surface may appear discolored when it is hot. This is temporary and will disappear as the glass cools. Troubleshooting 42 English