Sanyo CE32LD81 Instruction Manual - Page 6

Before Switching On Your TV Power Connection IMPORTANT: The TV set is designed to operate on 220-240V AC, 50 Hz. • After unpacking, allow the TV set to reach the ambient room temperature before you connect the set to the mains. Connections To The Aerial Input Socket • Connect the aerial or cable TV plug to the Aerial input socket located at the rear of the TV and connect the cable plug coming out from the TV out socket located on the devices (VCR, DVB etc.) to this socket as well. Note: Remove the battery from remote control handset when it is not to be used for a long period. Otherwise it can be damaged due to any leakage of battery. Switching The TV ON/OFF To switch the TV on: Your TV will switch on in two steps: 1- Connect the power supply cord to the system. Press Power On/Off button.Then the TV switches itself to stand-by mode (Optional). 2- To switch on the TV from stand-by mode either: Press a digit button on the remote control so that a programme number is selected, or Press the "-P/CH" or "P/CH+" button on the TV or press the "P+" or "P-" button on the remote control, so that last mode switched off is selected. By either method the TV will switch on. To switch the TV off: 75 VHF/UHF CABLE TV REAR OF THE TV Inserting Batteries In The Remote Control Handset WARNING : Remote control is battery included. A plastic protector is used to disconnect the batteries in order to prevent the battery life from reducing. Please remove the plastic protector before the first use. • Remove the battery cover located on the back of the handset by gently pulling backwards from the indicated part. • Insert two AAA/R03 or equivalent type batteries inside. Place the batteries in the right directions and replace the battery cover. • Press the " (stand-by)" button on the remote control or On/Off switch on the TV, so the TV will switch to stand-by mode. To power down the TV completely, press Power On/Off button or unplug the power cord from the mains socket. Navigating the Menu System For navigation M To confirm c ho ic es SELECT OK INFO For displaying menu options 1- Press "M" to display the menu. 2- Press "" or "" button to select an icon. Press "" for more options. 3- Use "" or "" button to highlight. 4- Press "" or "" buttons to change the settings. Press OK to set as default. 5- To exit the menu or return from sub-menu screen, press "M". These explanations are available for the navigation of the whole Menu System. To select options that are explained in the following parts, refer to "Navigating The Menu System". English - 5 -