Sanyo DP26647A Owners Manual - Page 5

GETTING STARTED (REQUIRED INITIAL SETUP) 1 Install batteries in remote control (2AAA, not included). 3 Plug in AC power cord (120V AC, 60 Hz). PRECAUTIONS To ensure safe operation, please observe the following precautions: Replace both batteries at the same time. Do not use a new battery with a used battery. Risk of explosion, if battery is replaced by an incorrect type. Do not expose the Remote Control Unit to moisture or heat. Match the "+" and "-" signs on the batteries with marks inside the remote control. 2 Connect Signal to the DTV's Integrated Analog / Digital 75 ohm Antenna Input terminal. RF ANTENNA OR CABLE OR CABLE BOX OR SATELLITE BOX DTV ANALOG/ DIGITAL ANTENNA IN THE TUNER IN THIS DTV CAN RECEIVE: 1. Digital and /or Analog Off-Air Signals from an RF antenna. OR 2. Analog or ClearQAM cable channels. Note: You must search for ClearQAM channels using the "Digital Cable Search" menu option. OR 3. The output from a VCR or cable box. Digital signals can also be received through the HDMI jacks. Digital signals from a Set-top (STB) Box should be received through the Video 1, 2, or 3, or HDMI Input1 or 2 jacks. This DTV can receive ANY unscrambled RF signal being broadcast. To 120 V AC outlet. 4 Press the POWER key. (Follow on-screen instructions.) 5 Perform "All Channel Search." The All Channel Search will search for off-air digital and analog channels, and analog cable chan- nels. The DTV can receive cable or off-air channels, but not at the same time. If after two searches the DTV still INITIAL ON-SCREEN ALL CHANNEL SEARCH fails to detect any channels, the DTV will tune to Video1. ANALOG CHANNELS DIGITAL CHANNELS « Note: If EXIT is pressed, the DTV will skip Channel Search and tune to Video1 without storing any channels in the Channel Map databases. Need help? Visit our Web site at www.sanyoctv.com or Call 1-800-877-5032 5