Sanyo DP26746 Owners Manual - Page 17

USING THE REMOTE CONTROL PRECAUTIONS To ensure safe operation, please observe the following precautions: Replace both batteries at the same time. Do not use a new battery with a used battery. Risk of explosion, if battery is replaced by an incorrect type. Do not expose the Remote Control Unit to moisture or heat. REMOTE CONTROL KEYS Œ Input Key-Press to change the input signal source as follows: Analog RF ¬ Digital RF ¬ Video 1 ¬ Video 2 ¬ Video 3 ¬ HDMI ¬ Analog RF.  Number Keys-Two keys must be pressed to select a direct channel. Example: Press 0 then 6 to select channel 6. For Analog Cable channels above 100, press and hold the 1 key until C1- - appears, then press the other two numbers. Ž Info Key-Press to display the Digital and Analog Full Banner information (press again to remove the display). Digital Full Banner display-Contains a twopart Channel Number (Major and Minor), and Tuner ID. If available the following is also included: Station ID, V-Chip Program Rating, Program Title, Audio Info, and Signal Strength. Tuner ID Channel Major Minor Station ID Program Rating Point toward DTV Œ  Ž Analog Full Banner display-Contains the Channel Number (analog antenna/cable), Tuner ID, Station ID (if available), Program Title (if available), V-Chip Program Rating, and Audio Info. Tuner ID Channel No. Station ID Program Rating « Program Title Audio Info Signal Strength Audio Info Program Title (Continued on page 18.) 17 Need help? Visit our Web site at www.sanyoctv.com or Call 1-800-877-5032