Sanyo DP26746 Owners Manual - Page 8

3 ALL CHANNEL SEARCH When the television is powered on for the first time, it automatically checks for the presence of an RF signal. • Press the Power key to turn on the DTV. • Then press the Channel Up (CH L) key to automatically search for available channels: Digital (ATSC) and Analog (NTSC). The All Channel Search contains two processes that are executed simultaneously for digital and analog channels. If the DTV does not detect any digital or analog channels, a message advising the viewer to check the cables and antenna connections will appear. In this case, you must press the CHANNEL UP (CH L ) key again to repeat the channel search process. If after two searches the DTV still fails to detect any channels, the DTV will tune to analog channel 3. These two channel searches are necessary even if you plan to use the DTV only as a monitor. If no analog or digital channels are found after the second search, All Channel Search will default to off-air analog channels 2 through 69 and digital channel D3-1. Select analog channels using the remote control keypad. See page 17, item number 2. « NOTES: The on-screen message for digital search will appear with a progress bar and percentile number displayed across the bottom of the screen (to indicate activity) as the search process continues. Channel information found during the All Channel Search is stored in Analog and Digital Channel Scan Memory databases. After the All Channel Search is completed, the DTV will tune to the lowest Digital channel or lowest Analog channel if no digital channels are found. 4 ANALOG ANTENNA SIGNAL (OPTIONAL) To change the initial analog tuning system setup (from antenna to cable or cable to antenna), use the on-screen menu, see "Analog Antenna Signal" on page 22. 8 Need help? Visit our Web site at www.sanyoctv.com or Call 1-800-877-5032