Sanyo EF60 Instruction Manual, PLC-EF60 - Page 53

Setting Setting PIN Code Change Logo PIN code can be changed to your desired four-digit number. Select "PIN code change" with the Control pad and press the SELECT button. Set a new Logo PIN code. Be sure to note the new Logo PIN code and keep it at hand. If you lost the number, you could no longer change the Logo PIN code setting. For details on PIN code setting, refer to relevant instructions of the PJ Lock function on page 57. Background 3 background settings are available in this projector. Select one of the followings when no input source is connected to the projector or no input signal is coming from the connected equipment: Blue . . . . . .blue colored background My logo . . .the image you captured Black . . . . .black colored background Lamp Control This feature allows you to change brightness of the screen. Normal . .normal brightness Auto . . . .brightness according with the input signal Eco . . . .lower brightness reduces the lamp power consumption and extends the lamp life. ✔Note: When using 100 W (optional) lamps, the Lamp control setting cannot be altered. Mode This projector is equipped with two lamps. Mode setting allows you to switch using 1 lamp or 2 lamps. 2-lamp . . . .lights both of the lamps inside the projector. 1-lamp . . .lights a lamp only. Auto, Lamp1, or Lamp2 can be altered. ✔Note: • When neither of the two lamps is lighted, the projector will shutdown automatically. • When either of the two lamps does not light up, the LAMP 1/2 REPLACE indicator is blinking red and the projector will light the other automatically. Remote control Four remote control channels and eight remote control ID are prepared for the projector to prevent radio frequency interference from the other equipment and mutual interference between projectors when using them at the same time. For example, operating the projector in "CH-2 and ID-7," both the projector and the remote control must be switched to "CH-2 and ID-7." To change CH and ID for the projector; Select a remote control CH and ID in this Setting menu. To change CH and ID for the remote control; While holding down the CH or ID button, press the SELECT button. The remote control CH or ID switches sequentially for one pressing the SELECT button. Changing CH and ID should be done separately. (See page 16 and 17 for details.) PIN Code change Dialog Box Select PIN code change and press the SELECT button. The PIN code input dialog box will appear. Pointer Lamp Control Lamp Mode When selecting Auto in 1-Lamp mode, the projector automatically selects either lamp of which the total Lamp time is shorter and lights it up. Remote control Pointer The setting selected. When pressing the SELECT button at Remote control, the remote control CH and ID menu appears. Select CH and ID respectively. 53