Sanyo HD150 Owners Manual - Page 14
Connecting To Computer
View all Sanyo HD150 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
CONNECTING PROJECTOR CONNECTING TO COMPUTER Cables used for connection (✽ = Cables are not supplied with this projector.) • DVI Cable • DVI-VGA Cable (HDB 15 pin) • MAC/VGA Adapter • BNC Cable (BNC x 5) ✽ • Audio Cables (RCA x 2) ✽ NOTE : When connecting cable, power cords of both a projector and external equipment should be disconnected from AC outlet. Turn a projector and peripheral equipment on before computer is switched on. IBM-compatible computers or Macintosh computers (VGA / SVGA / XGA / SXGA/UXGA) Desktop type Laptop type Monitor Output Monitor Output MAC/VGA Adapter Set slide switches following chart below. Monitor Output DVI Cable BNC Cable ✽ Audio Output Audio Cable (stereo) ✽ DVI-VGA Cable 14 SERIAL PORT IN SDI IN1 SDI IN2 SDI OUT INPUT 1 AUDIO OUT SERIAL PORT OUT R/C JACK USB AUDIO OUT R L RESET (MONO) R/Pr G/Y B/Pb H/HV V AUDIO R L CONTROL PORT (MONO) DVI AUDIO CONTROL PORT R L (MONO) INPUT 4 INPUT 3 INPUT 2 Terminals of a Projector MAC/VGA ADAPTER Audio Cable (stereo) ✽ Audio Input External Audio Equipment Audio Amplifier Audio Speaker (stereo) Switches of MAC/VGA Adapter ON OFF ON DIP 123456 Set switches as shown in table below depending on RESOLUTION MODE that you want to use before your turn on a projector and computer MODE SWITCHES 1 2 3 4 5 6 13"MODE (640 x 480) ON ON OFF OFF OFF OFF 16"MODE (832 x 624) OFF ON OFF ON OFF OFF 19"MODE (1024 x768) OFF ON ON OFF OFF OFF 21"MODE (1152 x 870) ON ON ON ON OFF OFF