Sanyo PLC-XP200L Instruction Manual, PLC-XP200L - Page 33

Basic Operation MOUSE POINTER button Move the pointer on the screen with this button. Remote Control POINTER button Press POINTER button on the remote control to display the Pointer on the screen. P-TIMER button Press the P-TIMER button on the remote control. The Timer display "00 : 00" appears on the screen and starts to count time (00 : 00-59 : 59). To stop the P-TIMER, press the P-TIMER button. To cancel the P-TIMER, press the P-TIMER button again. KEYSTONE button P-Timer display MOUSE POINTER button POINTER button P-TIMER button FREEZE button FILTER button FREEZE button Press the FREEZE button on the remote control to freeze the picture on the screen. To cancel the FREEZE function, press the FREEZE button again or press any other button. ✔Note: • See the previous page for the description of other buttons. FILTER button Press and hold the FILTER button for more than five seconds to operate electrically operated filter to replace the filter. ✔Note: • The filter cannot be rewound. • When the filter is replaced, the total accumulated time of the filter use is automatically set to 0. KEYSTONE button Press the KEYSTONE button on the remote control. The "Keystone" appears on the screen. Use the Point ed7 8 buttons to correct keystone distortion. The keystone adjustment can be stored (pp.44, 48). • The white arrows indicate that there is no correction. • A red arrow indicates the direction of correction. • An arrow disappears at the maximum correction. • If you press the KEYSTONE button on the remote control again while the Keystone dialog box is being displayed, the keystone adjustment will be canceled. • The adjustable range can be limited depending on the input signal. • "Keystone" disappears after 10 seconds. Reduce the upper width with Point e button. Reduce the lower width with Point d button. Reduce the left part with Point 7 button. Reduce the right part with Point 8 button. 33