Schwinn 810 Treadmill Assembly and Owners Manual - Page 43

TROUBLESHOOTING Condition/Problem No display/partial display/ unit will not turn on Unit operates but Contact HR not displayed Speed display is not accurate Console shuts off (enters sleep mode) while in use Fan will not turn on or will not turn off Fan will not turn on, but Console operates Unit rocks/does not sit level Things to Check Check electrical (wall) outlet Check connection at front of unit Check data cable integrity Check data cable connections/orientation Check console display for damage Console Display Sensor grip Dry or calloused hands Display set to wrong unit of measure. (English/ Metric) Check electrical (wall) outlet Check connection at front of unit Check data cable integrity Check data cable connections/orientation Reset machine Reset machine Check for blockage of fan Check leveler adjustment Check surface under unit Solution Make sure unit is plugged into a functioning wall outlet. Test the outlet with a known functioning device such as a lamp. Connection should be secure and undamaged. Replace power cord or connection at unit if either are damaged. All wires in cable should be intact. If any are visibly crimped or cut, replace cable. Be sure cable is connected securely and oriented properly. Small latch on connector should line up and snap into place. Check for visual sign that console display is cracked or otherwise damaged. Replace Console if damaged. If Console only has partial display and all connections are fine, replace the Console. If the above steps do not resolve the problem, contact Customer Service (if inside US/Canada) or your local distributor (if outside US/Canada). Be sure hands are centered on HR sensors. Hands must be kept still with relatively equal pressure applied to each side. Sensors may have difficulty with dried out or calloused hands. A conductive electrode cream (heart rate cream) can help make better conduct. These are available on the web or at medical or some larger fitness stores. If the above steps do not resolve the problem, contact Customer Service (if inside US/Canada) or your local distributor (if outside US/Canada). Change display to show correct units. Make sure unit is plugged into a functioning wall outlet. Test the outlet with a known functioning device such as a lamp. Connection should be secure and undamaged. Replace adapter or connection at unit if either are damaged. All wires in the cable should be intact. If any are cut or crimped, replace cable. Be sure cable is connected securely and oriented properly. Small latch on connector should line up and snap into place. Unplug unit from electrical outlet for 3 minutes. Reconnect to outlet. If the above steps do not resolve the problem, contact Customer Service (if inside US/Canada) or your local distributor (if outside US/Canada). Unplug unit from electrical outlet for 5 minutes. Reconnect to outlet. Unplug unit from electrical outlet for 5 minutes. Remove material from fan. If necessary, detach the Console to help with removal. Replace the Console if unable to remove blockage. Adjust levelers until machine is level. Adjustment may not be able to compensate for extremely uneven surfaces. Move machine to level area. 43