Sennheiser Set 880 Instruction manual Set 880 - Page 33

Using additional functions Using additional functions The following additional functions are not required for normal use of the wireless headphone system. You can, however, extend the potential use of the system and adjust some of the functions to your individual needs. Pairing one or several stethoset receivers with the transmitter The stethoset receiver and the transmitter of your wireless headphone system are factory pre-paired. The following steps are only necessary if you want to pair additional stethoset receivers with the transmitter. You can simultaneously use up to 4 paired stethoset receivers with your transmitter. All other paired and switched-on receivers cannot connect to the transmitter. 1...4 If more than one stethoset receiver is connected to the trans- mitter, the remaining operating time/charge status and the hearing profile cannot be displayed. In addition, the balance and a hearing profile cannot be adjusted. These functions can only be used/adjusted when only one stethoset receiver is connected to the transmitter. Option A (contact pairing) E Place the stethoset receiver into the transmitter's charging compartment. The stethoset receiver is paired with the transmitter. Option B (proximity pairing) 1 Place the stethoset receiver as close as possible to the transmitter. 2 Switch the stethoset receiver on by pulling the ear bows apart. 3 Simultaneously press and hold the volume buttons +/-. Once paring is completed, the Transmitter status LED flashes white. Release the buttons. 1 2 3 ON Set 880 | 33