Sennheiser Set 880 Instruction manual Set 880 - Page 36

Using additional functions 36 | Set 880 Battery status display This setting is saved on the transmitter, independent of the stethoset receiver you are using. To change the battery status display: E Make sure that the protected settings mode is activated (see page 35). E Press the Balance button L. Status and display of the Battery LED Function/behavior permanently activated The current charge status is (operation and charging)* permanently displayed during charging. The remaining charge status is permanently displayed during 1st LED segment lit operation. activated for 30 seconds (operation and charging) 1st LED segment off The current charge status is displayed for 30 seconds during charging. Then all LEDs go off. The charging process is continued. The remaining charge status is displayed for 30 seconds during operation. The battery status display then goes off. * factory setting E Save the setting by disconnecting the transmitter from the power supply system (see page 35). Charging reminder function This setting is saved on the transmitter, independent of the stethoset receiver you are using. To activate or deactivate the function: E Make sure that the protected settings mode is activated (see page 35). E Press the Balance button R. Status and display of the charging reminder function Function/behavior activated* 5th LED segment lit When you switch the stethoset receiver off and the transmitter switches to standby mode, the battery status display will flash for 10 minutes to remind you to charge the stethoset receiver. deactivated 5th LED segment off After switching the wireless headphone system off, all LEDs remain off. * factory setting E Save the setting by disconnecting the transmitter from the power supply system (see page 35).