Sennheiser Set 880 Instruction manual Set 880 - Page 41
The rechargeable battery is
View all Sennheiser Set 880 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
If a problem occurs ... Problem Possible cause Possible solution Page The balance is misadjusted. Adjust the balance. 26 Sound only on one ear The audio cable is not properly connected. Check the audio plug connection. 11 The TV has only a mono headphone socket. Use an adapter (mono to stereo jack socket) to connect the transmitter to the TV. - Sound is less spatial Mono operation is activated. Activate stereo operation. 34 The audio cable is defective. Replace the audio cable. - Sound is distorted The signal of the audio source is distorted. The volume on the stethoset receiver is adjusted too high. Reduce the volume of the audio source. - Reduce the volume on the stethoset receiver. 25 You hear echoes when using the stethoset receiver with a Some TVs can adjust a delay or latency of the audio signal for the digital audio output. Check the audio output settings of your TV and set the latency to "0". - TV The battery status display goes off The battery status display is set so that it goes off after 30 seconds. Set the battery status display so that it is permanently displayed. 36 More than one stethoset receiver is This function is only possible when currently connected to the trans- only one stethoset receiver/receiver is - mitter. connected to the transmitter. 2 beeps during operation The rechargeable battery is almost empty. Recharge the rechargeable battery. 16 The operating The rechargeable battery is time decreases exhausted. Have the rechargeable battery replaced by an authorized Sennheiser 32 service partner. A hearing profile, the balance or stereo/mono operation cannot be activated or changed The settings protection function is activated. Deactivate the settings protection function (for the hearing profile, the balance and stereo/mono operation). 37 More than one stethoset receiver/ receiver is currently connected to the transmitter. This function is only possible when only one stethoset receiver/receiver is connected to the transmitter. - The stethoset receiver is not paired Pair the stethoset receiver with the with the transmitter. transmitter. 33 The stethoset receiver does not connect to The distance to the transmitter is too large. Reduce the distance between the stethoset receiver and the transmitter. - the transmitter 4 stethoset receivers are currently connected to the transmitter. Up to 4 stethoset receivers can be simultaneously used with the transmitter. - If a problem occurs that is not listed in the above table or if the problem cannot be solved with the proposed solutions, visit the Set 880 product page at www.sennheiser.com for the most up-to-date list of frequently asked questions. You may also contact your local Sennheiser partner for assistance. To find a Sennheiser partner in your country, search at www.sennheiser.com. Set 880 | 41