Sharp 37HV4U User Manual - Page 69

Other viewing options Learning remote control function You can operate the connected AV products (AV Receiver, Cable Box, SAT tuner, DTV, VCR, DVD, LD) using the learning function for your remote control unit. This remote control unit has the function that can memorize each remote control code. TV POWER TV CBL VCR DVD /SAT /LD /DTV ANT-A/B INPUT AV FRONT MODE SURROUND MTS CC VIEW MODE TWIN PICTURE FREEZE SELECT SUB INPUT TWIN CH DISPLAY SLEEP EDIT/ LEARN 123 456 789 0 100 ENT 0.8 to 2.0 inch (2 to 5 cm) Presetting manufacturer codes 1 Slide the Mode switch to match the device to which you want to preset the remote control signal. 2 Press EDIT/LEARN and 1 at the same time. • LED flashes continuously. 3 Press 0 - 9 to enter the manufacturer code. (See page 69.) • Preset mode is finished once the LED no longer lights up. NOTE • To stop the EDIT mode in the middle, press EDIT/LEARN once more. • If Mode switch is switched while in EDIT mode, EDIT mode will be canceled. • If there is no operation for over 1 minute running, exit this mode. • When you enter a code that is not listed, LED flashes quickly. • If the table on page 69 does not include your desired manufacturer or the remote control does not work, you can make the memory learn its signal by the learn mode. • The initial mode is "00". Learning the remote control TV POWER AV MODE SURROUND VIEW MODE DISPLAY ‫؀‬ VOL ‫؁‬ MENU RETURN SOURCE POWER A TV CBL VCR DVD ANT-A/B FRONT TWIN PICTURE FREEZE SLEEP /SAT /DTV 123 456 789 0 FLASHBACK RETURN MUTE TV/SAT/DVD MENU SET/ ENTER FAVORITE CH B INPUT RECEIVER INPUT MTS SELECT SUB INPUT C VOL‫؁‬ /LD EDIT/ LEARN CC TWIN CH 100 ENT CH DTV/DVD TOP MENU DTV/SAT GUIDE DTV/SAT INFO VCR REC D VOL‫؀‬ 1 Be sure to slide the Mode switch to match the device whose remote control signal you want to be learned. Remote control Remote control of 2 Press EDIT/LEARN and 2 at the same time. (Supplied accessory) AV product • LED flashes continuously. 3 Press a button for you want to learn. • Refer to the assigning buttons to functions on each page.(See page 70 to 75.) • The LED changes from lit up to flashing state. • When the learn mode is finished, LED lights up once and returns to the learn mode (LED flashes continuously). 4 To exit learn mode, press EDIT/LEARN. NOTE • To stop the EDIT mode in the middle, press EDIT/LEARN once more. • If Mode switch is switched while in EDIT mode, EDIT mode will be canceled. • If there is no operation for over 1 minute running, exit this mode. • If TV POWER is pressed over 2 seconds running (LED flashes continuously, step 2 above), the learning codes of the current Mode switch position clear, changing back to preset manufacturer codes. In this case, the LED turns off after 2 seconds exiting learning mode. 68