Sharp AR-208 AR-208S AR-208D Operation Manual Suite - Page 63
Troubleshooting And, Maintenance - d troubleshooting
UPC - 708562050784
View all Sharp AR-208 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
8 Chapter 8 TROUBLESHOOTING AND MAINTENANCE Problems related to general use of the machine, the copy function, and software setup are explained here. Be sure to check the problem carefully before calling for service, as many problems can be solved by the user. If you are unable to solve the problem, turn off the main switch, unplug the power cord from the outlet, and contact your dealer. Note For problems related to the printer and scanner functions, see the online manual. DISPLAY MESSAGES When the following indicators light up or blink on the operation panel or the following alphanumeric codes appear in the display, solve the problem immediately referring to both the table below and the indicated page. Note Be sure to use only genuine SHARP parts and supplies. Indication Lamp indicator Display Cause and remedy Page Tray location Blinks indicator BYPASS : ADD PAPER TRAY : ADD PAPER CLOSE PAPER TRAY The indicated paper tray is not attached, is attached incorrectly, or has run out of paper. (The tray is indicated 15 in .) CLEAR PAPER JAM. A paper misfeed has occurred. Remove the misfeed as explained in 70 SPF/RSPF JAM. "MISFEED REMOVAL". FRONT OR SIDE COVER OPEN. The cover is open. Close the cover. - CLOSE COVERS. CLOSE THE SPF/ The RSPF cover is open. Close the RSPF COVER. RSPF cover. - REPLACE THE The toner cartridge is empty. Replace TONER CARTRIDGE. the toner cartridge with a new cartridge. 74 Error indicator Blinks When [L1-00] appears, the scan head locking switch is locked. Turn off the power, release the scan head locking 76 switch, and turn the power back on. When [F2-02] appears, check the toner SYSTEM ERROR cartridge and make sure that the seal - [XX - XX] REFER is not still affixed. TO USER GUIDE The machine will not function. Turn the power switch off, wait about 10 seconds, and then turn on the switch again. If this does not clear the error, remove the - power cord from the outlet, and contact your SHARP service center. 8 61