Sharp AR-F14 AR-F14 Saddle-Stitch Finisher Operation Manual - Page 17

USING THE KEY OPERATOR PROGRAMS When the saddle stitch finisher is installed on the multifunction machine, the key operator programs indicated below are added or changed. For information on "USING THE KEY OPERATOR PROGRAMS", see page 2 of the "Key operator's guide" that comes with the machine. I Added programs The following two programs are added to "DEVICE CONTROL" (page 12 of the "Key operator's guide"): Disabling of finisher This program is used to prohibit use of the saddle stitch finisher. The program is also used if the finisher fails. When use of the finisher is prohibited, the staple function, saddle stitch function, punch function, and output destination are grayed out. Saddle stitch position adjust This program is used to adjust the stapling position (folding position) when the saddle stitch function is used. The position can be shifted within a range of ±3.0 mm from the base position in increments of 0.1 mm. When "AUTOMATIC SADDLE STITCH" is disabled and "SADDLE STITCH" is selected in "OUTPUT", the display does not change to the pamphlet setting screen. Max. +3 mm Position when shifted to the "+" side Max. -3 mm Position when shifted to the "-" side 1 2 12 11 Base position I Changed programs The "OUTPUT TRAYS" and "INITIAL STATUS SETTINGS" programs are changed when the saddle stitch finisher is installed. Output trays A combination of output destinations can be selected for copying, printing, and fax in "OUTPUT TRAYS" in "DEVICE CONTROL". When the saddle stitch finisher is installed, the combinations that can be selected are as shown at right. Selections PATTERN 1 PATTERN 2 PATTERN 3 PATTERN 4 Description Copying: Offset tray Printing: Center tray Fax: Center tray Copying: Center tray Printing: Offset tray Fax: Center tray Copying: Center tray Printing: Offset tray Fax: Offset tray Copying: Offset tray Printing: Center tray Fax: Offset tray Note If the machine does not have the fax function, "PATTERN 3" and "PATTERN 4" do not appear and the tray positions in "PATTERN 1" and "PATTERN 2" change. Initial status settings The stapling position when the copy settings are returned to the default settings can be selected. Select the stapling position for the staple sort function in "OUTPUT" in "INITIAL STATUS SETTINGS" of the "COPY FUNCTION SETTINGS". 15