Sharp AR M162 AR-M162 AR-M207 Operation Manual Suite - Page 219
Problems And Solutions
View all Sharp AR M162 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 219 highlights
PROBLEMS AND SOLUTIONS If you experience a problem with the fax function, first check the following table. This section describes problems related to the fax function. For problems related to general operation of the machine, see "TROUBLESHOOTING" in the "Operation manual (for general information and copier)". Problem The machine does not operate. Dialling is not possible. Cannot send a fax. The transmitted image prints out blank at the receiving side. Check Solution Page Is the machine power switch turned on? Turn the power switch ON. "Power switch" on page 4 Does the display show an error message? Clear the error as instructed by the message. "WHEN AN ALARM SOUNDS AND A WARNING MESSAGE IS DISPLAYED" on page 88 Is the telephone line properly connected? Check the connections. "Line connection" on page 4 Is the machine power switch turned on? Turn the power switch ON. "Power switch" on page 4 Is the machine in fax mode? Press the [FAX] key to set "BASIC PROCEDURE the machine to fax mode. FOR SENDING FAXES" on page 18 Does the receiving fax machine have paper? Check with the operator of the receiving machine. Does the receiving machine support G3 transmission? Are the sub-address and - passcode correct? (When using F-code transmission) Is the receiving machine ready to receive? Are you using a transmittable original size? Check the transmittable sizes. "ORIGINALS THAT CAN BE FAXED" on page 12 Was the original size detected correctly? Check size of the original. "CHECKING THE SIZE OF A PLACED ORIGINAL" on page 14 The message "Reading If you attempt cancelled. Please retry transmission while the sending operation." message "Warming-up." appears. appears, the transmission - may not take place correctly. Repeat the transmission. Was the original placed so Make sure the original is that the correct side is placed so that the correct scanned? side is scanned. "PLACING THE ORIGINAL" on page 13 If the receiving machine is Check with the operator of using thermal paper, was the receiving machine. the thermal paper loaded - with the wrong side out? 90