Sharp CD-CH1500 CDCH1500 Operation Manual - Page 15
Setting the Clock
![]() |
View all Sharp CD-CH1500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Setting the Clock 5 Turn the jog dial to adjust the hour and within 2 minutes, press the ENTER button. When the 12-hour display is selected, "AM" will change automatically to "PM". 6 Turn the jog dial to adjust the minutes and within 2 minutes, press the ENTER button. Basic Operation - Setting the Clock - In this example, the clock is set for the 12-hour (AM12:00) display. 1 Press the POWER button to turn the power on. 2 Press the MENU button. 3 Turn the jog dial to select "CLOCK" and within 10 seconds, press the ENTER button. q The hour will not advance even if minutes advance from "59" to "00". q The clock starts from "0" second. (Seconds are not displayed.) The time display will disappear after a few seconds. To confirm the time display: [When the unit is in the stand-by mode] Press the DISPLAY button on the remote control. The time display will appear for about 3 seconds. [When the power is on] Press the MENU button. The time display will appear for about 10 seconds. Note: "CLOCK" will appear or time will flash at the push of the DISPLAY button when the AC power supply is restored after a power failure or unplugging the unit. Reset the clock as follows. 4 Turn the jog dial to select the 12-hour or 24-hour display and within 2 minutes, press the ENTER button. "AM 12:00" → The 12-hour display will appear. (AM 12:00 - PM 11:59) "AM 0:00" → The 12-hour display will appear. (AM 0:00 - PM 11:59) "0:00" → The 24-hour display will appear. (0:00 - 23:59) Note that this can only be set when the unit is first installed or it has been reset. [Refer to "Clearing all the memory (reset)" on page 30 for details.] To reset the clock: [When time is flashing] 1. Press the POWER button. 2. Press the MENU button. 3. Press the ENTER button. 4. Perform "Setting the Clock" from step 5. [When "CLOCK" appears] Perform "Setting the Clock" from the beginning. To change the 24-hour or 12-hour display: 1. Clear all the programmed contents. [Refer to "Clearing all the memory (reset)" on page 30 for details.] 2. Perform "Setting the Clock" from the beginning. 15
![](/manual_guide/products/sharp-cdch1500-cdch1500-operation-manual-2858ed4/15.png)