Sharp CD-DD4500 CDDD4500 Operation Manual - Page 42

References - Troubleshooting Chart - Troubleshooting Chart (continued) s Clearing all the memory (reset) 1. Press the POWER button to enter the power stand-by mode. 2. While pressing down the 0 / R button and X-BASS/DEMO button, press the POWER button until "CLEAR AL" appears. Caution: This operation will erase all data stored in memory including clock, timer settings, tuner preset, CD program, and other set-up details. When TIMER indicator is flashing The unit will be overheated when TIMER indicator is flashing. Due to a problem in the speaker circuit, the unit will enter the stand-by mode automatically. In this case, take the following corrective actions. 1. Unplug the AC power plug from the AC outlet. 2. Make sure that the unit vent is not blocked. 3. Make sure that the speaker wires have been correctly connected to the speaker terminals. 4. After checking items 2 and 3 above, wait for 2 or 3 hours before trying to use the unit. 5. Reconnect the AC power cord. s Before transporting the unit 1. Press the POWER button to turn the power on. 2. Press the CD button. 3. Press the 7 OPEN/CLOSE button to open the disc tray. Remove all CDs inserted the unit. 4. Press the 7 OPEN/CLOSE button to close the disc tray. Make sure that "NO DISC" is displayed. 5. Press the POWER button to enter the stand-by mode, and then unplug the AC power cord from the AC outlet. Note: If the TIMER indicator flashes again during use, please unplug the AC power plug, and contact a SHARP authorized service center. 42