Sharp DV-RW350U Operation Manual - Page 100

Others Error message Recording Error You cannot record more than 99 titles on one disc. (The maximum is 99) Recording Error You cannot record more than 999 chapters on one disc. (The maximum is 999) Troubleshooting (cont'd) Cause Solution You are trying to record onto the disc on which the number of recording titles comes up to the maximum (99). Delete unnecessary titles (pages 61, 65, 74). You are trying to record onto the VR mode DVD-RW disc on which the number of recording chapters comes up to the maximum (999). Delete unnecessary chapter markers (pages 69, 78). Recording Error You cannot record on this disc as Control Information is full. This disc has no space to write the Control Information when recording or deleting contents. When editing has been repeatedly performed, the control Information area may come up to be full even the recording area has enough space. Delete unnecessary titles (pages 61, 65, 74). Recording Error You cannot record on the disc as Power Calibration Area is full. When recordings are performed repeatedly onto an unstable disc, this area may come up to be full. Every time you insert a disc for recording, the disc's working area will be taken up. And if you repeat this frequently, it will be used up sooner and you may not be able to record full 99 titles. Insert a new disc. Recording Error This disc is already finalized. You are trying to record onto the disc already finalized. Release the finalizing for this disc (page 41). * If you are still having trouble with this unit after checking Troubleshooting, write down the error code and the error description, and contact a Sharp Authorized Service Center for inspection. (See Service Information on page 103.) You can watch the TV programs with the tuner of the unit. (Usually channel 3 or 4 of the TV is available for the RF converter setting.) Be sure to connect the unit to a TV using the Round Coaxial cable. Refer to page 14. 1 Select channel 3 on your TV. • Be sure that the unit is in DVD mode. 2 Press VIDEO/TV button on the remote control. • If noise appears, change the RF output channel of the unit to CH 4 by pressing VIDEO/TV button for 3 seconds.The RF output channel will alternate between CH3 and CH4 as follows. 100 RF converter output 1 GHI 4 PQRS 7 DISPLAY 2 JKL 5 TUV 8 SPACE 0 VCR 3 MNO CH 6 WXYZ VIDEO/TV 9 SLOW DVD PAUSE for more than 3 seconds 3 seconds (RF ON) CH4 3 seconds (RF ON) CH3 3 seconds (RF ON) CH4 3 seconds • Changing the RF output channel is available only when the unit is in DVD mode. POWER REC MODE REC SPEED AUDIO OPEN/CLOSE .@/: 1 GHI 4 PQRS 7 DISPLAY ABC 2 JKL 5 TUV 8 SPACE 0 VCR DEF 3 MNO CH 6 WXYZ VIDEO/TV 9 SLOW DVD PAUSE PLAY STOP REC/OTR SETUP TIMER PROG. REC MONITOR ENTER MENU/LIST TOP MENU RETURN CLEAR/C.RESET ZOOM SKIP SEARCH MODE CM SKIP SKIP 2