Singer S10 I STUDIO Instruction Manual - Page 28

vbn m,. zx wr q e Step v Lower the presser foot. Press the start/stop button and sew 5 to 6 stitches. Step b Press the start/stop button again to stop the machine. Raise the presser foot. Trim the thread tail at the beginning of the stitching. Step n Lower the presser foot and press the start/stop button. The machine will sew the first color section and stop automatically when it has finished. Step m Select OK √ and change the thread to its next color. Sew the next section. Step , Continue sewing and changing threads until the design is finished. The machine will buzz when design is complete. Select the OK √ button to return to the beginning of design. Step . Select the exit X button to return to the design selection screen. Needle or Bobbin Thread Breaks When embroidering a design, thread breakage can occur. Also, the bobbin may run out of thread before the design is finished. Follow these steps to re-thread the machine and return the needle to the position where stitching should resume. Step z Raise the presser foot. Check that the machine has not run out of bobbin thread. Rewind bobbin if needed and replace in bobbin case. Check that the thread is feeding evenly off of the thread spool and re-thread the needle. If the carriage position makes threading the needle difficult, you can move the hoop for easier threading by pressing the home position button q. After rethreading the needle thread, press the home position button q again to return the carriage to the previous position. q Home position button Step x Press the stitch back button w or stitch forward button r to move the embroidery hoop to where the thread broke or quit stitching e. Press the stitch back once w to move the hoop back by 10 stitches. w Stitch back button e Point of thread breakage r Stitch forward button 28