Sony BDV-IZ1000W Operating Instructions - Page 59
Clearing all the preset and programmed remote codes from the remote’s memory
View all Sony BDV-IZ1000W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
Other Operations • You cannot use z individually. z is used with H, X, or x. When learning, press H, X, or x while pressing z. 9 Point the remotes at each other. 10 Press the button on the other remote that you want to program to the supplied remote. Note • If you do not press a button for more than 10 seconds after Step 8, the supplied remote status returns to its status after Step 7. Re-perform from Step 8. 11 Repeat Steps 8 to 10 to continue programming more buttons. If you successfully program the remote code, the BD operation mode button will flash twice slowly. If the setting is unsuccessful, the TV or STB operation mode button will flash five times quickly. Note • You can exit from Learning mode by pressing the TV or STB operation mode button (whichever button is flashing). • If you do not press a button to be programmed during Learning mode for more than 1 minute, the remote exits from Learning mode. To clear a programmed remote code 1 Follow Steps 1 to 7 of "Programming the remote code from another remote (Learning mode)." 2 Press [/1 for more than 1 second. The TV or STB operation mode button flashes twice. 3 Press the button on the supplied remote for which you want to clear the remote code. If you successfully clear the remote code, the BD operation mode button will flash twice slowly. If the clearing is unsuccessful, the BD operation mode button will flash five times quickly. 4 Repeat Step 3 to continue clearing more buttons. Note • When you clear the programmed remote code, the button's operation returns to the default setting. Clearing all the preset and programmed remote codes from the remote's memory 1 Press and hold AV ?/1 first, then press VOL -, then press CH -. The BD, TV, and STB operation buttons light up. 2 Release all buttons. The BD, TV, and STB operation mode buttons turn off and all the added remote codes are cleared. The remote returns to its default settings. Saving Power in Standby Mode Check that the following settings are made: - [Control for HDMI] in [HDMI Settings] is set to [Off] (page 51). - [Standby] in [S-AIR Settings] is set to [Off] (page 48). - [Quick Start Mode] is set to [Off] (page 65). 59US