Sony BRC300 Operating Instructions - Page 20
Sony BRC300 Manual
View all Sony BRC300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Rear/Bottom MODE RS-232C VISCA RS-422 TALLY/CONTACT CONTACT(TALLY) TALLY ! ON/OFF 1 9 1 9 CONTACT DC IN 12V wa ws wd wf wg wh wj wk U MODE selector Select the position corresponding to the VISCAcontrollable camera to be connected. Switch position 0 1 2 3 4 Note Camera mode Automatically selected (default) BRC-300/300P EVI-D70/D70P EVI-D100/D100P EVI-D30/D30P Y TALLY/CONTACT selector Select the function of the TALLY/CONTACT connector. TALLY: The tally lamp of the camera selected with the connected switcher lights. CONTACT: The contact output corresponding to the camera address selected with the Remote Control Unit is short-circuited against the connected switcher. CONTACT (TALLY): The contact output corresponding to the camera address selected with the Remote Control Unit is short-circuited against the connected switcher and the tally lamp of the camera selected with the connected switcher lights. Note Overview Change the setting of the selector before you turn on the power of the Remote Control Unit. Otherwise, the setting is not effective. wh DC IN 12V connector Connect the supplied AC power adaptor. wj DIP switches (bottom) Switch 1 (RS-232C/RS-422 selector) Set to ON for RS-422, or OFF for RS-232C. Switch 2 (Communication baud rate selector) Set to ON for 38400bps, or OFF for 9600bps. Note Use position 1 to 4 when all the connected cameras are of the same model. V VISCA RS-232C connector Connect to the VISCA RS-232C IN connector of the camera or the BRU-300/300P Optical Multiplex Unit. W VISCA RS-422 connector Connect to the VISCA RS-422 connector of the camera or the BRU-300/300P Optical Multiplex Unit. An RS-422 connector plug is attached at the factory. X TALLY/CONTACT connector This connector is used for the tally lamp input or the contact output. Select the function of the connector using the TALLY/CONTACT selector. An RS-422 connector plug is attached at the factory. Set the DIP switches before you turn on the power of the Remote Control Unit. Otherwise, the setting is not effective. wk ON/OFF switch Press this switch to turn on/off the Remote Control Unit. 20 Location and Function of Parts