Sony BRC300 Operating Instructions - Page 30
Sony BRC300 Manual
View all Sony BRC300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
DISPLAY INFO When the camera settings are stored in POSITION 1 to 6 using the supplied Remote Commander (page 34), the message "PRESET No. xx" automatically appears for 2 seconds on the monitor screen. If you want to display the message each time the camera is operated, set DISPLAY INFO to ON. Set it to OFF to cancel the display. ANALOG OUT Menu The ANALOF OUT menu appears only when the BRBK-301 Anaolog RGB Component card is installed in the card slot of the camera. >OUTPUT 1 SYNC OUTPUT 2 RGB G VBS Adjusting and Setting With Menus OUTPUT 1 Select the signal output from pins 3, 4 and 5 of the 9-pin D-sub connector of the Analog RGB Component Card. Set to RGB for the RGB signal output, or YCrCb for the component signal output. When RGB is selected, SYNC appears, and you can select the sync signal from among G, RGB, and OFF. OUTPUT 2 Select the signal output from pin 6 of the 9-pin D-sub connector of the Analog RGB Component Card. Set to VBS for the composite signal output, or Y/C for the S video signal output. 30 ANALOG OUT Menu