Sony CCD-TR3000 Operation Manual - Page 56
Using, Battery
View all Sony CCD-TR3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
Tips for Using the Battery Pack This section shows you how you can get the most out of your battery pack. Preparing the Battery Pack Always Carry Additional Batteries Have sufficient battery pack power to do 2 to 3 times as much recording as you have planned. Battery Life is Shorter in a Cold Environment Battery efficiency is decreased and the battery will be used up more quickly if you are recording in a cold environment. To Save Battery Power Close the STANDBY cover when not recording to save battery power [a]. A smooth transition between scenes can be made even if recording is stopped and started again. While you are positioning the subject, selecting an angle, or looking through the viewfinder lens, the lens moves automatically and the battery is used. The battery is also used when a tape is inserted or removed. When to Replace the Battery Pack While you are using your camcorder, the remaining battery indicator in the viewfinder decreases gradually as battery power is used up. ci +(Imo +4 4+4 +c When the remaining battery indicator reaches the lowest point, the f---\3 indicator appears and starts flashing in the viewfinder [b]. When the indicator in the viewfinder changes from slow flashing to rapid flashing while you are recording, slide the POWER switch to OFF on the camcorder and replace the battery pack. Leave the tape in the camcorder to obtain a smooth transition between scenes after the battery pack is replaced. Notes on the Rechargeable Battery Pack Caution Never leave the battery pack under temperatures above 140°F (60°C), such as in a car parked in the sun or under direct sunlight. The Battery Pack Heats Up During charging or recording, the battery pack heats up. This is caused by energy that has been generated and a chemical change that has occurred inside the battery pack. This is not cause for concern. Battery Pack Care • Remove the battery pack from the camcorder after using the battery pack, and keep it in a cool place. When the battery pack is installed to the camcorder, a small amount of current flows to the camcorder even if the POWER switch is set to OFF, which shortens battery life. • The battery pack is always discharging even when it is not in use after charging. Therefore, you should charge the battery pack right before using the camcorder. 56