Sony DCRHC38 Operating Guide - Page 12
To use an outside power source, To remove the battery pack, When storing the battery pack
UPC - 027242701809
View all Sony DCRHC38 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Step2: Charging the battery pack (Continued) 5 The CHG (charge) lamp turns off when the battery is fully charged. Disconnect the AC Adaptor from the DC IN jack. Disconnect the AC Adaptor from the DC IN jack holding both the camcorder and the DC plug. To use an outside power source You can operate your camcorder using the power from the wall outlet by making the same connections as you do when charging the battery pack. The battery pack will not lose its charge in this case. To remove the battery pack 1 Turn off the power, then press PUSH. 2 Remove the battery pack in the direction of the arrow. POWER switch 1 2 PUSH When storing the battery pack Fully discharge the battery before storing it for an extended period (p. 59). To check the remaining battery (Battery Info) Set the POWER switch to OFF(CHG), then press DISP/BATT INFO. After a while, the approximate recordable time and battery information appear for about 7 seconds. You can view the battery information for up to 20 seconds by pressing DISP/BATT INFO again while the information is displayed. Remaining battery (approx.) BATTERY INFO BATTERY CHARGE LEVEL 0% 50% 100% REC TIME AVAILABLE LCD SCREEN : 85 min VIEWFINDER : 99 min Recording capacity (approx.) You can check the remaining battery charge on the LCD screen. Indicator Status Sufficient power remaining Battery low, recording/ playback will stop soon. Replace the battery with a fully charged one, or charge the battery. Charging time Approximate time (min.) required when you fully charge a fully discharged battery pack. Battery pack NP-FH30 (supplied) NP-FH50 NP-FH70 NP-FH100 Charging time 115 135 170 390 12