Sony DCRHC38 Operating Guide - Page 54

Troubleshooting (Continued) You cannot dub correctly using the A/V connecting cable. • The A/V connecting cable is not connected properly. Make sure that the A/V connecting cable is connected to the input jack of another device for dubbing a picture from your camcorder (p. 42). New sound added to a recorded tape is not heard. • Adjust [AUDIO MIX] until the sound is heard appropriately (p. 34). Pictures from connected devices are not displayed correctly. • The input signal is not NTSC (p. 57). Connecting to a computer The computer does not recognize your camcorder. • Install the "Picture Motion Browser" (p. 47). • The computer may not recognize your camcorder for a few moments after you connect it. Wait for a while. • Disconnect USB devices other than the keyboard, the mouse, and the camcorder from the (USB) jack on the computer. • Disconnect the cable from the computer and camcorder, restart the computer, then connect them again correctly. You cannot install the supplied software, "Picture Motion Browser," on a Macintosh computer. • You can install "Picture Motion Browser" only on a Windows computer. Functions that cannot be used together Depending on the functions, you may not be able to use them together. The following list shows examples of functions that cannot be used at the same time. Not available If this function is set BACK LIGHT [SPOT METER], [EXPOSURE] [SPOT FOCUS] [SCENE SEL.] [SPOT METER] NightShot plus [SCENE SEL.] NightShot plus [EXPOSURE] NightShot plus [WHT BAL] NightShot plus 54