Sony DG510 Operating Instructions - Page 67
Specifications, AUDIO POWER - parts
UPC - 027242705685
View all Sony DG510 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
PROTECT Irregular current is output from the speakers. The receiver will automatically turn off after a few seconds. Check the speaker connection and turn on the power again. If you are unable to remedy the problem using the troubleshooting guide Clearing the receiver's memory may remedy the problem (page 26). However, note that all memorized settings will be reset to their factory settings and you will have to readjust all settings on the receiver. If the problem persist Consult your nearest Sony dealer. Note that if service personnel changes some parts during repair, these parts may be retained. Reference sections for clearing the receiver's memory To clear All memorized settings Customized sound fields See page 26 page 52 Specifications AUDIO POWER SPECIFICATIONS POWER OUTPUT AND TOTAL HARMONIC DISTORTION: (Models of area code U only) With 8 ohm loads, both channels driven, from 20 - 20,000 Hz; rated 90 watts per channel minimum RMS power, with no more than 0.09% total harmonic distortion from 250 milliwatts to rated output. Amplifier section Models of area code U, CA1) Minimum RMS Output Power (8 ohms, 20 Hz - 20 kHz, THD 0.09%) 90 W + 90 W Stereo Mode Output Power (8 ohms, 1 kHz, THD 1%) 100 W + 100 W Surround Mode Output Power2) (8 ohms, 1 kHz, THD 10%) 130 W/ch Models of area code CEL, CEK, AU, TW1) Minimum RMS Output Power (8 ohms, 20 Hz - 20 kHz, THD 0.09%) 85 W + 85 W Stereo Mode Output Power (8 ohms, 1 kHz, THD 1%) 100 W + 100 W Surround Mode Output Power2) (8 ohms, 1 kHz, THD 10%) 130 W/ch Models of area code SP, E21) Minimum RMS Output Power (8 ohms, 20 Hz - 20 kHz, THD 0.09%) 70 W + 70 W Stereo Mode Output Power (8 ohms, 1 kHz, THD 1%) 80 W + 80 W Surround Mode Output Power2) (8 ohms, 1 kHz, THD 10%) 120 W/ch continued 67GB Additional Information