Sony DPT-S1 Operating Instructions - Page 77
Digital Paper Device, Power On/Off, Battery - battery replacement
View all Sony DPT-S1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 77 highlights
Tip Replace the stylus tip periodically to prevent damage to the Digital Paper device and maintain smooth operation. If you have used the supplied replacement tips, new stylus tips are sold separately. Digital Paper Device Power On/Off The Digital Paper device will not turn on. The device cannot be operated if connected to your computer and set to transfer data. Use the Safely Remove Hardware function of your computer, and then disconnect the USB cable from the device. Moisture condensation may have occurred. Wait for a few hours, then turn it on. If the battery is completely depleted, you may not be able to turn on the device. Charge the device by connecting it to the supplied AC adapter or your computer via the supplied USB cable, and the device will turn on. If the device still does not turn on, press the (Power) button. If the Charge indicator blinks red 3 times upon pressing the (Power) button, it shows that the device battery is completely depleted. To charge the device, insert the supplied USB cable into the micro USB port and connect it to the supplied AC adapter, or connect the device to a computer using the supplied USB cable. If the battery is completely depleted, it may take up to 5 minutes for the device to turn on. The Digital Paper device automatically enters sleep mode or turns off. To conserve the battery's charge, the device includes automatic power saving modes. The device will enter sleep mode after 1 hour of inactivity. After 3 days* in sleep mode, it will shut down/power off automatically. * If the battery's charge is low, the device may automatically turn off within 3 days. Battery Cannot charge the Digital Paper device. If you use equipment other than the supplied USB cable or AC adapter to charge the device, it may not charge correctly. We do not guarantee the performance and safety of the device. To charge the device, use only the supplied USB cable, or the supplied AC adapter (page 8). If you are charging from the USB port on your computer, make sure that the device is connected directly to the USB port with the supplied USB cable. If you connect the computer using a USB hub, we do not guarantee the performance of the device. The battery has not been given enough time to fully charge. Charge the device until the icon changes to the icon. (The charge icon does not indicate the remaining battery power while charging.) If you are charging from a USB port on your computer, your computer must be turned on to charge the device. The device will not be charged if your computer enters sleep mode, standby mode or hibernation. Keep your computer turned on with a stable and continuous power supply while charging the device. When you set [Screen Transfer] to On and charge the device by connecting the device to your computer via USB cable, check if the dedicated driver is installed onto the computer (page 57). The device cannot be charged through the computer if the installation of the driver is not completed. If your computer enters sleep mode while the device is connected and charging, the device battery's charge will gradually drain, the device will shut down and its battery will not charge. In this case, disconnect the USB cable from the device, wake the computer from sleep mode, then reconnect the USB cable to the device. Your computer may not be supplying sufficient power. If you connect the device to your laptop computer, maintain a stable and continuous power supply to the laptop computer while charging the device. 77