Sony DSX-S310BTX Operating Instructions - Page 32

Bluetooth (Handsfree calling and Music streaming) Bluetooth Operations To use the Bluetooth function, the following procedure is necessary. 1 Pairing When connecting Bluetooth devices for the first time, mutual registration is required. This is called "pairing." This registration (pairing) is required only for the first time, as this unit and other devices will recognize each other automatically from the next time. You can pair with up to 9 devices. 2 Connecting After pairing is made, connect this unit and the Bluetooth device. Depending on the device, connection automatically made along with the pairing. 3 Handsfree calling/Music streaming You can make/receive a handsfree call, or listen to audio through this unit. For details of usable devices, visit the following support site. Support site http://esupport.sony.com http://www.sony.com/mobileAV Signal strength status of connected cellular phone.* Remaining battery status of connected cellular phone.* * Turns gray without handsfree connection. Differs in the case of a cellular phone. Installing the microphone To capture your voice during handsfree calling, you need to install the microphone (supplied). For details on how to connect the microphone, refer to the supplied "Installation/Connections" guide. Pairing First, register ("pair") a Bluetooth device (cellular phone, etc.) and this unit with each other. You can pair up to 9 devices. Once pairing is established, there is no need for pairing again. 1 Press and hold (BLUETOOTH). " " flashes (pairing is in standby mode). 2 Set the Bluetooth device to search for this unit. A list of detected devices appears in the display of the device to be connected. This unit is displayed as "Sony Automotive" on the device to be connected. About Bluetooth icons The following icons are used by this unit. Lit: Bluetooth signal is on. Flashing: Pairing is in standby mode. None: Bluetooth signal is off. Lit: Flashing: None: Connected to a cellular phone. Connection is in progress. No cellular phone is connected for handsfree calling. Lit: Connected to a device. Flashing: Connection is in progress. None: No device is connected for music streaming. Lit: Flashing: None: Some unread SMS messages exist. A new SMS message has been received. No unread SMS messages exist. 32 DR-BT30Q Sony Automotive XXXXXXX 3 If passkey* input is required on the display of the device to be connected, input "0000." XXXX Input passkey. "0000" This unit and the Bluetooth device memorize each other's information, and when pairing is made, this unit is ready for connection to the device.