Sony FWD-40LX2F Operating Instructions - Page 72
Other Information, Troubleshooting - 32
UPC - 027242705166
View all Sony FWD-40LX2F manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
Other Information Troubleshooting Check whether the POWER/STANDBY indicator is flashing red. When it is flashing The self-diagnosis function is activated. 1 Check how many times the POWER/STANDBY indicator flashes and how long it stops flashing. For example, the indicator flashes 2 times, stops flashing for 3 seconds, and flashes 2 times. 2 Press 1 on the display (top side) to switch off, disconnect the power cord. Inform your dealer or Sony service center of how the indicator flashes (the number of flashes and the duration of light out). When it is not flashing 1 Check the items in the table below. 2 If the problem still persists, have your display serviced by qualified personnel Problem The power switch and control buttons on the display do not work. No picture. No picture. Possible Remedies • Check "Control Setting" (page 30). • Check "ECO Mode" settings (page 29). The display turns off automatically. No picture from some video sources. • Check if "Timer Setting" is activated (page 29). • Check the connection between the video equipment and the display. • Try switching input using the INPUT button of the display, or the remote control (page 7, 12, 13). Poor picture. No color/Dark picture/The picture is too bright/Color is not correct No sound/Noisy sound. • Press PICTURE to select the desired "Picture Mode" (page 12). • Adjust the "Picture Mode" options in the "Picture" settings (page 22). • Check the condition of the signal cable. Good picture, no sound. "Wide Mode" setting changes automatically. Remote control does not operate. • Check the volume control. • Press on the remote control or + so that "Muting" disappears from the screen (page 13). • Check "Common Audio Sel." settings (page 24). • Check "Speaker Out" settings (page 24). • The current "Wide Mode" setting automatically changes to the appropriate setting for the current input if "Auto Wide" in the "Screen" settings is set to "On". If you want to retain the current "Wide Mode" setting as inputs are changed, set "Auto Wide" to "Off" in the "Screen" settings (page 25). • Check the polarity of the batteries or replace the batteries. • Point the remote control at the remote control sensor of the display. • Keep the remote control sensor area clear from obstacles. • Check "Control Setting" (page 30). • Check whether a cable is connected to the CONTROL S IN connector. The remote control cannot be used while the display is controlled via a CONTROL S connection. • Fluorescent lamps can interfere with remote control operation; try turning off the fluorescent lamps. 32 GB