Sony GDM-500PS Operating Instructions - Page 13

4 Fine tuning the color temperature Press the ¨./> buttons to select an item and adjust by pressing the >?// buttons. COLOR 1 6500K 9300K R B I AS 76 G B I AS 50 B B I AS 50 R GAIN 50 G GAIN 50 B GAIN 50 Select R (red), G (green), or B (blue) BIAS to adjust the black level of each color's signal. Select R (red), G (green), or B (blue) GAIN to adjust the white level of each color's signal. The "5000K," "6500K" or "9300K" disappears and the new color settings are memorized for each of the three color modes. The color temperature modes change as follows: 5000Kn 1, 6500Kn 2, 9300Kn 3 The OSD automatically disappears after about 30 seconds. To close the OSD, press the MENU button again. To reset, press the RESET button while the OSD is on. The selected item is reset to the factory settings. GCeuttsitnogmSiztianrgteYdour Monitor Using the SCREEN On-screen Display You can adjust convergence settings to eliminate red or blue shadows that may appear around objects on the screen. Adjust the CANCEL MOIRE function to eliminate wavy or elliptical patterns that may appear on the screen. Adjust the LANDING function to correct color imbalances at the four corners of the screen due to influence from the earth's magnetism. Once CANCEL MOIRE is adjusted, it will be stored in memory for the current input signal. All other adjustments will be stored in memory for all input signals received. 1 Press the MENU button. The MENU OSD appears. MENU 2 Press the ¨./> and >?// buttons to select " SCREEN," and press the MENU button again. EN The SCREEN OSD appears. F SCREEN ES TOP BOT 26 ADJ C H CONVERGENCE 3 Press the ¨./> buttons to select the item you want to adjust. Select H CONVERGENCE V CONVERGENCE TOP V CONVER TOP BOT V CONVER BOTTOM To adjust the horizontal convergence adjust the vertical convergence adjust the screen's upper vertical convergence adjust the screen's lower vertical convergence (continued) 13