Sony HAR-D1000 Primary User Manual - Page 15

Recording tips -- Marking track numbers/Smart Space/Adjusting the recording level When using the remote, set SELECT to HDD. Marking track numbers while recording You can marking track numbers either manually or automatically while recording. By marking track numbers at specific points, you can quickly locate the points later or edit the HDD easily. Marking track numbers manually (Track Mark) During manual recording, press HDD z at the point where you want to add a track number. Marking track numbers automatically (Level Synchro Recording) When recording from a CD player or MD deck connected to the DIGITAL OPTICAL IN connector, the recorder automatically marks track numbers in the same sequence as the sound source. When recording from other sound sources connected to the DIGITAL OPTICAL IN connector or a sound source connected to the ANALOG IN jacks, do the procedure below to mark track numbers automatically. However, you cannot mark track numbers automatically if the sound source you want to record is noisy (e.g., tapes or radio programmes). 1 While the recorder is stopped or recording pause, press MENU/NO. "Edit Menu" appears in the display. 2 Turn ALBUM dial (or press ALBUM +/- on the remote repeatedly) until "Setup?" flashes in the display, then press ALBUM dial or YES. "Setup Menu" appears in the display. 3 Turn ALBUM dial (or press ALBUM +/- on the remote repeatedly) until "T.Mark Lsyn" (or "T.Mark Off") appears in the display, then press ALBUM dial or YES. 4 Turn ALBUM dial (or press ALBUM +/- on the remote) to select the setting, then press ALBUM dial or YES. To Turn on the Level Synchro Recording function Turn off the Level Synchro Recording function Select T.Mark Lsyn. (factory setting) T.Mark Off. 5 Press MENU/NO. When you set Level Synchro Recording to on, "L.SYNC" appears in the display. The recorder marks a track number whenever the input signal level drop to the trigger level for Level Synchro Recording or below for at least 1.5 seconds. To change the trigger level for Level Synchro Recording Do the procedure below to change the signal level that triggers Level Synchro Recording. 1 While the recorder is stopped or recording pause, press MENU/NO. "Edit Menu" appears in the display. 2 Turn ALBUM dial (or press ALBUM +/- on the remote repeatedly) until "Setup?" flashes in the display, then press ALBUM dial or YES. "Setup Menu" appears in the display. continued Recording to HDD 15