Sony KDE-42XS955 Operating Instructions - Page 7

s Leave some space around the unit. Otherwise, adequate air-circulation may be blocked causing overheating and cause fire or damage the unit. When installing the unit on the wall 30 cm (11 7/8 inches) 10 cm (4 inches) 10 cm (4 inches) When installing the unit using a stand 10 cm (4 inches) Allow this much space. 30 cm (11 7/8 inches) AC power cord Unplug the AC power cord when moving the unit. Do not move the unit with the AC power cord plugged in. It may damage the AC power cord and result in fire or electric shock. Preventing from toppling over Take measures to prevent the unit from toppling over and causing injury. To prevent the unit from toppling over, secure the unit to the wall or pillar. Installing on a level surface If you install the unit on an inclined surface, the unit may fall or drop and cause injury or damage. Placing on a stable surface If you place the unit on an unstable surface, the unit may fall and cause injury or damage. 10 cm (4 inches) Never install the unit as follows: Air circulation is blocked. 10 cm (4 inches) Allow this much space. Air circulation is blocked. Fall Do not hang anything on the unit. The unit may fall from the stand or wall-mount unit, causing damage or serious injury. Power-Cord Protection Do not allow anything to rest on or roll over the power cord, and do not place the unit where the power cord is subject to wear or abuse. Outdoor use Do not install this unit outdoors. If the unit is exposed to rain, it may result in fire or electric shock. If the unit is exposed to direct sunlight, the unit may heat up and it may damage the unit. Vehicle and ceiling Do not install this unit in a vehicle or hung from the ceiling. Bumping of the vehicle may cause the unit to fall down and cause injury. Ship and vessel Do not install this unit in a ship or vessel. If the unit is exposed to seawater, it may cause fire or damage the unit. Antennas Outdoor Antenna Grounding If an outdoor antenna is installed, follow the precautions below. An outdoor antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can come in contact with such power lines or circuits. WHEN INSTALLING AN OUTDOOR ANTENNA SYSTEM, EXTREME CARE SHOULD BE TAKEN TO KEEP FROM CONTACTING SUCH POWER LINES OR CIRCUITS AS CONTACT WITH THEM IS ALMOST INVARIABLY FATAL. Be sure the antenna system is grounded so as to provide some protection against voltage surges and built-up static charges. Section 810 of the National Electrical Code (NEC) in USA and Section 54 of the Canadian Electrical Code in Canada provides information with respect to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna discharge unit, connection to grounding electrodes, and requirements for the grounding electrode. (Continued) 5