Sony KDF-60XBR950 Operating Instructions - Page 30
Cable Box Only, projection TV's VHF/UHF jack.
![]() |
UPC - 027242633186
View all Sony KDF-60XBR950 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
Installing and Connecting the LCD Projection TV Cable Box Only For best results, use this connection if: ❑ Your cable company scrambles all channels, which requires you to use a cable box. ❑ You do not have a VCR. (If you have a VCR, see pages 32 and 33.) With this connection you can: ❑ Use the LCD projection TV remote control to change channels coming through the cable box to the LCD projection TV's VHF/UHF jack. (You must first program the remote control for your specific cable box.) About Using This Connection with Dual Picture (Twin View, etc.) Features With this connection, all channels come into the LCD projection TV through your cable box and only one unscrambled signal is sent to the LCD projection TV, so you cannot use the dual picture features. If some of your channels are scrambled, but others are not, consider using the "Cable Box and Cable Only" connection on page 28 instead. To connect the cable box 1 Connect the CATV cable to the cable box's input jack. 2 Use a coaxial cable to connect the cable box's output jack to the LCD projection TV's VHF/UHF jack. 3 Run the Auto Setup program, as described in "Setting Up the LCD Projection TV Automatically" on page 45. CATV cable Coaxial cable VHF/UHF Rear of LCD projection TV 30 IN Cable box OUT Notes on Using This Connection To do this... Use the cable box Set up the LCD projection TV remote control to operate the cable box Do This ... Tune the LCD projection TV to the channel the cable box is set to (usually channel 3 or 4) and then use the cable box to switch channels. Program the remote control. See "Programming the Remote Control" on pages 48.
![](/manual_guide/products/sony-kdf70xbr950-operating-instructions-2183a96/30.png)