Sony KDL-52XBR10 Operating Instructions - Page 12

Connecting the Unit Cable System or VHF/UHF Antenna System You can enjoy high-definition and standard-definition digital programming (if available in your area) along with standard-definition analog programming. This unit is capable of receiving unscrambled digital programming for both cable (QAM and 8VSB) and external VHF/UHF antenna (ATSC). Cable or VHF/UHF (or VHF only) 75-ohm coaxial cable Rear of media receiver CABLE/ ANTENNA • It is strongly recommended that you connect the CABLE/ANTENNA input using a 75-ohm coaxial cable to receive optimum picture quality. A 300-ohm twin lead cable can easily be affected by radio frequency interference, resulting in signal degradation. Cable System and VHF/UHF Antenna System Use an optional A-B RF switch (not A-B RF Switch supplied) to switch between the cable and over-the-air antenna programming, Cable A as shown here. Antenna B Set the Cable/Antenna setting found under the Settings on the XMB™ to Cable or Antenna for the type of input signal you choose. Rear of media receiver CABLE/ ANTENNA HD Cable Box/HD Satellite Box You can enjoy high-definition programming by subscribing to a high-definition service or a highdefinition satellite service. For the best possible picture, make sure you connect this equipment to your media receiver via the HDMI or component video (with audio) input located on the rear of the media receiver. Shown with HDMI Connection Rear of media receiver 1 CABLE/ ANTENNA 2 VIDEO IN 1 R AUDIO L PR PB Y COMPONENT IN (1080p/1080i/720p/480p/480i) R AUDIO L AUDIO OUT (VAR/FIX) AUDIO (OPTICAL) DIGITAL AUDIO OUT DMex/ SERVICE RGB PC IN 1 R AUDIO L AUDIO IN 3 REMOTE 4 IN LAN HDMI cable CATV/Satellite antenna cable HD cable box/ HD satellite box 12