Sony KLV-23HR2 Operating Instructions - Page 14
Connecting a Satellite Receiver with a VCR - remote control
View all Sony KLV-23HR2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Installing and Connecting the TV Connecting a Satellite Receiver with a VCR Disconnect all power sources before making any connections. 1 Connect the satellite antenna cable to the satellite receiver's SATELLITE IN jack. 2 Connect the CATV cable to the VCR's VHF/UHF IN jack. 3 Using the supplied 75-ohm coaxial cable, connect the VCR's OUT jack to the TV's VHF/UHF jack. 4 Using AUDIO and S VIDEO cables, connect the satellite receiver's AUDIO and S VIDEO OUT jacks to the VCR's AUDIO and S VIDEO IN jacks. 5 Using AUDIO and S VIDEO cables, connect the VCR's AUDIO and S VIDEO OUT jacks to the TV's AUDIO and S VIDEO IN jacks. Satellite antenna Satellite receiver cable 75-ohm coaxial cable (supplied) S VIDEO S VIDEO cable (not supplied) VCR AUDIO cable (not supplied) VIDEO (yellow) AUDIO-L (white) AUDIO-R (red) Rear of TV Cable 75-ohm coaxial cable (supplied) S VIDEO cable (not supplied) AUDIO cable (not supplied) Note To watch the pictures input from the S VIDEO input jack, set "Auto YC" to "On" in the (Setup) menu (See page 12). Tips • You can also use the VIDEO 2 IN jacks to connect your VCR. • Be sure your VCR's video input is set correctly. Consult your VCR's operating manual for instructions. • Use TV/VIDEO on the remote control to select VIDEO 1 IN (or VIDEO 2 IN if you use the VIDEO 2 IN jacks for this hookup) to watch satellite TV or to watch a tape on the VCR (your VCR must be turned on). • If your VCR or satellite receiver is not equipped with S VIDEO, use a VIDEO cable (yellow) instead of the S VIDEO cable. 14