Sony KZ-42TS1 Operating Instructions - Page 49
KZ-32/42TS1U 4-087-364 - kz 42ts1u no sync
View all Sony KZ-42TS1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
Menu category Menu item Screen Zoom Screen Control Adjust Pixel Custom Setup Display Screen Saver Color Matrix RGB Mode Sync Mode Adjusting Your Setup Setting option Select to enlarge the picture with the center position fixed (only when "Wide Mode" is set to "Full"). Select from "Standard" (normal size), "×2" (doubled), "×3" (tripled), or "×4" (quadrupled). Select to adjust the picture from an RGB equipment. Auto Adjust: Select "OK" to make best possible adjustment for the input signal automatically. Note that it may not be adjusted perfectly depending on the input signal condition or picture pattern. In this case, perform "Auto Adjust" again. Dot Phase: Adjust in the range of "01" - "62" if part of a displayed text or image is not clear. Total H Pixel (Total Horizontal Pixel): Adjust when the letter or picture is not clear as a whole. Reset: Reset to the factory settings. Select "On" to display which input is selected. Select to reduce image retention. Pic. Orbit (Picture Orbit) (To prevent image retention) Move the picture position to reduce image retention. This does not prevent image retention completely if the same picture is displayed for an extended period of time. Orbit: Select "On" to move the position. If you select "On," set "Orbit Range" and "Orbit Cycle." Orbit Range: Select the moving range from "Large," "Mid" (Middle), and "Small." Orbit Cycle: Select the moving time from "10sec," "30sec," "1min," and "5min." Select to give the picture a neutral tint, if the output signal from the DVD player connected to the COMPONENT VIDEO IN jacks is 525p (480p), 1125i (1080i), or 750p (720p) signal format. Adjust this only when the picture tint goes out of tune. Select the signal format for each input, then set it to "Y/Cb/Cr," or "Y/Pb/Pr." When purchasing, all formats are set to "Y/Pb/Pr." Select if an equipment which outputs the RGB signal is connected to the Y/G, PB/B, PR/R jacks of the COMPONENT VIDEO IN 2/RGB IN jacks. DTV: Select when a digital tuner with RGB signal is connected. Others: Select when other RGB equipment is connected. Set according to the input signal from the HD jack of the COMPONENT VIDEO IN 2/ RGB IN jacks. H/Comp: Select when the input signal is a horizontal synchronized signal or a composite signal. Video: Select when the input signal is a video signal. 01US08AJ3-UC(48-50).p65 49 US (Continued) (US) 49 2002.6.22, 3:10 PM KZ-32/42TS1U 4-087-364-13 (1)