Sony MEXBT5700U Operating Instructions - Page 8
Preparing the card remote commander, Setting the clock, Detaching the front panel, Caution alarm
UPC - 027242744875
View all Sony MEXBT5700U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Preparing the card remote commander Remove the insulation film. Tip For how to replace the battery, see page 35. Setting the clock The clock uses a 12-hour digital indication. 1 Press and hold the select button. The setup display appears. 2 Rotate the control dial until "Clock Adjust" appears. 3 Press the select button. 4 Rotate the control dial to set the hour, then press the select button. 5 Rotate the control dial to set the minute, then press the select button. To move the digital indication, press (SEEK) +/-. The setup is complete and the clock starts. Detaching the front panel You can detach the front panel of this unit to prevent theft. Caution alarm If you turn the ignition switch to the OFF position without detaching the front panel, the caution alarm will sound for a few seconds. The alarm will only sound if the built-in amplifier is used. 1 Press (OFF). The unit is turned off. 2 Press (OPEN). The front panel is flipped down. 3 Slide the front panel to the right, then gently pull out the left end of the front panel. Notes • Do not drop or put excessive pressure on the front panel and display window. • Do not subject the front panel to heat/high temperature or moisture. Avoid leaving it in a parked car or on a dashboard/rear tray. • Do not detach the front panel during playback of the USB device, otherwise USB data may be damaged. 8