Sony MHC-GX9900 MHCGX9900 Instructions (main component system) - Page 46
Messages, above occur, reset the system - how to reset
View all Sony MHC-GX9900 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
The tape does not record. • No tape is loaded. Load a tape. • The tab has been removed from the tape. Cover the broken tab with adhesive tape (page 49). • The tape has reeled to the end. The system cannot play back the reverse side of the tape in Deck A. • The system only can play back front side of the tape in Deck A. This is not a malfunction. When you turn . > clockwise or counterclockwise (or press -. or >+ on the remote), "Not in Use" flashes in the display. • The system does not has AMS (Automatic Music Sensor) function. This is not a malfunction. If the system still does not operate properly after performing the above measures or other troubles does not described above occur, reset the system as follows: Use buttons on the unit for the operation. 1 Unplug the power cord. 2 Plug the power cord back in. 3 Press ?/1 to turn on the system. 4 Press x, ENTER and ?/1 at the same time. The system is reset to the factory settings. You should set the settings you made, such as the preset stations, clock and timer. Messages One of the following messages may appear or flash in the display during operation. Disc NO STEP You have cleared all the steps you programmed. OVER You have reached the end of the disc while turning and holding m M clockwise (or pressing M on the remote) during playback or pause. No Disc There is no disc on the disc tray. Push STOP! You have pressed PLAY MODE on the remote during playback. Step Full! You tried to program more than 25 steps. Reading The system is reading information of the disc. Some buttons are not available. Tape No Tab You cannot record the tape because the tab has been removed from the tape. No Tape There is no tape in the tape deck. 46GB