Sony MZ-R501 Operating Instructions - Page 21

5 While observing the level meter in the display, adjust the recording level by pressing SELECT >/.. Set the level so that the maximum input lights up the fifth segment on the level meter. If the sixth segment lights up, lower the level by pressing SELECT >. fifth segment Checking the remaining time or the recording position You can check the remaining time, track number, etc. when recording or during stop. SELECT >/. Recording does not start in this step. If your source is an externally connected component, be sure to cue the source to the beginning of the material to be recorded before you start playback. 6 Press X again to start recording. To stop recording Press x. The recording level control is switched back to automatic control when you record the next time. Notes • The recording level cannot be adjusted while recording is in progress. If you want to adjust the recording level after you have started the recording, press X to pause the recorder. Then do the procedure from step 5. • You cannot adjust the recording level manually during synchro-recording. MENU/ENTER 1 While the recorder is recording or stopped, press MENU/ENTER, press SELECT >/. repeatedly until "DISP" flashes in the display, and then press MENU/ENTER again. 2 Press SELECT >/. repeatedly until the information you want flashes in the display. Each time you press SELECT ., the display changes as follows. LapTim (elapsed time) r RecRem (remaining time for recording)1) r AllRem (remaining time after the current location) 1)"RecRem" start flashing in the display when the remaining time for recording become 3 minutes or less. continued 21