Sony PDW700 User Manual (PDW-700 / PDW-F800 Operation Manual for Firmware Vers - Page 30
AUDIO IN CH1/CH2 audio channel-1, SDI OUT 2 connector BNC type
View all Sony PDW700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
Chapter 1 Overview Device Enables Windows USB Text input wth the on-screen keyboard or mouse software keyboard (see page 124) USB flash drive Recording of proxy data (see page 104) Loading of planning metadata (see page 136) Before using this connector, you must set ETHERNET/USB on the POWER SAVE page of the OPERATION menu to "ENABL" (see page 212). d (network) connector (RJ-45 type) This is a 10BASE-T/100BASE-TX connector for network connection. Before using this connector, you must set ETHERNET/USB on the POWER SAVE page of the OPERATION menu to "ENABL" (see page 212). CAUTION For safety, do not connect the connector for peripheral device wiring that might have excessive voltage to this port. Follow the instructions for this port. When you connect the network cable of the unit to peripheral device, use a shielded-type cable to prevent malfunction due to radiation noise. e EARPHONE jack (stereo, minijack) You can monitor the E-E sound during recording and playback sound during playback. When an alarm is indicated, you can hear the alarm sound through the earphone. You can use this with the EARPHONE jack on the front of the unit at the same time. Plugging an earphone into the jack automatically cuts off the built-in speaker. You can select monaural or stereo on the AUDIO1 page of the MAINTENANCE menu. f LINE / AES/EBU / MIC selectors These select the audio source of the audio input signals input to the AUDIO IN CH1/CH2 connectors. LINE: Line input audio equipment AES/EBU: AES/EBU format audio signal MIC: Microphone input Note When these switches are in the MIC position, and the +48V/OFF switch is set to +48V, if you inadvertently connect any audio device other than a microphone to the AUDIO IN CH1/CH2 connectors, the device may be damaged. g +48V/OFF switches Select either of the following positions for the microphones to be connected. +48V: For a microphone to use an external power supply OFF: For a microphone to use an internal power supply h REMOTE connector (8-pin) Connect an RM-B150/B750 remote control unit, which makes it possible to control the camcorder remotely. Note Before connecting/disconnecting the Remote Control Unit to/from the camcorder, be sure to turn off the camcorder POWER switch. i SDI OUT 1 connector (BNC type) Outputs an HDSDI or SDSDI signal (with embedded audio). To switch between HDSDI and SDSDI output, use the SDI OUT 1 SELECT item on the OUTPUT 1 page of the OPERATION menu. j SDI OUT 2 connector (BNC type) Outputs an HDSDI or SDSDI signal (with embedded audio). To switch between HDSDI and SDSDI output, use the SDI OUT 2 SELECT item on the OUTPUT 1 page of the OPERATION menu. Setting menus, timecode, or shot data can be superimposed on the camera output video depending on the menu settings, and you can view them on the monitor screen. k AUDIO IN CH1/CH2 (audio channel-1 and channel-2 input) connectors (XLR type, 3-pin, female) These are audio input connectors for channels 1 and 2 to which you can connect audio equipment or a microphone. When the LINE / AES/EBU / MIC selector is set to AES/EBU, the CH1 connector is used for channel-1 and -2 inputs, and the CH2 connector, for channel-3 and -4 inputs. 30 Locations and Functions of Parts and Controls