Sony RM-AV2100 Operating Instructions (primary manual) - Page 10
Checking if the code number works, Aim the Commander at - remote codes
UPC - 027242612044
View all Sony RM-AV2100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Setting the Code for Preset Audio and Visual Components (continued) Notes • If you press a component code number that is not on the table in the supplied "Component Code Numbers", the Commander beeps and "NG" flashes after you press the ENTER key. If this happens, check the component code number, and try setting again. • If you don't input anything into the Commander for over two minutes between each step, the setup procedure will be canceled. To set the code, you must again press MUTING while pressing COMMANDER OFF. To check which code number is set Press the DISPLAY key in Step 3 to 5. The code number and "ENTER" appear twice. Checking if the code number works 1 Press the corresponding Component Select button for the component you have set up. The Commander turns on and the touch-keys appear on the display. 2 Power on the component with its power switch. 3 Aim the Commander at the component and press the POWER key in the touch-key display. When the remote control signal is sent, is displayed on the display. The component should power off. 10