Sony RM-AV2100 Operating Instructions (primary manual) - Page 33
control amplifier in this example, on the component's remote
UPC - 027242612044
View all Sony RM-AV2100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
Example : To program the input select signal of your amplifier to the CD button 1 Place the RM-AV2100 head to head with your component's remote control. Remote control of your component 3 Press the desired Component Select button. The selected component name stays lit and "LEARN" flashes. about 2 - 4 inches (5 - 10 cm) away RM-AV2100 2 While pressing COMMANDER OFF, press CHANNEL + and VOLUME +. 4 Press and hold down the button on the component's remote control (amplifier in this example) until you hear a beep. (If you release the button before you hear a beep, the signal may not be learned correctly.) "LEARN" appears and all the component names flash. Note The name of a Component Select button for which a signal has already been learned stays lit. If you want to program a new signal for that button by learning, clear the learned signal first (page 34). "LEARN" stops flashing and stays lit. If "NG" flashes on the display Learning did not succeed. Try Steps 3 and 4 again. 5 Press COMMANDER OFF. Continued 33