Sony SNC-M1 User Guide - Page 21
System log Tab, Access log Tab, Factory default, Firmware upgrade
View all Sony SNC-M1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Factory default Resets the camera to the factory settings. Click Factory default, and "Set up data will be initialized. Are you sure?" appears. When you click OK, the network indicator and the power indicator on the camera start to blink. After adjustments of the default settings have finished, the camera reboots automatically. Do not turn off the camera until the camera reboots. Tip The camera can also be reset to the factory settings by pressing the reset switch on the camera. For details, see the supplied Installation Manual. Note When the camera is reset to the factory settings, the IP address you set is cleared. After rebooting of the camera, input the IP address again (page 8). Firmware upgrade Use this when upgrading the camera software. Click Browse and specify the file for upgrading, then click OK. "Upgrade firmware? Are you sure?" is displayed. Click OK and upgrading starts. After completion, the camera starts again. Notes • Use only the upgrade file special to this camera. If you do not, a problem may occur. • Do not turn off the camera until the upgrading will be completed. System log Tab Access log Tab Access log The access record of the camera is displayed. Click Reload to reload to the latest data. Administrating the Camera System log The data of the software activity of the camera are recorded in this. It includes data that are useful when a problem occurs. Click Reload to reload to the latest data. 21 Configuring the System - System setting menu